VideoJet X20

Configuration Using a Web Browser en 57

 

 

5.19.1Standard profile

From this field, you can select the encoder profile to be used for continuous recording (see Section 5.11 Encoder Profile, page 38).

i

NOTICE!

The recording profile can deviate from the standard setting Active profile for the video input

set and is only used during an active recording.

 

 

5.19.2

Encoder

 

Here you can select the data stream to be used for the recording.

5.19.3

Alarm track recording

 

 

i

NOTICE!

This parameter is active only if alarm tracks have been configured for the camera input

concerned, i.e. the corresponding partition (see Section 5.18.8 Number of alarm tracks,

page 55).

 

 

 

XClick the checkbox to activate alarm track recording. The pre-alarm time is automatically displayed for information.

5.19.4Post-alarm time

You can select the required post-alarm time from the list field.

5.19.5Post-alarm profile

You can select the encoder profile to be used for recording during the post-alarm time (see Section 5.11 Encoder Profile, page 38).

The Standard profile option adopts the selection for continuous recordings at the top of the page.

5.19.6Alarm input / Motion alarm / Video loss alarm

Here you can select the alarm sensor that is to trigger a recording. You can also use the motion and video alarm for a camera to trigger the alarm recording by another camera.

NOTICE!

The motion alarms are configured and activated for each camera on the VCA page (see

Section 5.23 VCA, page 64).

i

The alarm inputs are configured and activated on the Alarm Sources page (see

 

 

Section 5.21 Alarm Sources, page 60).

 

The numbering of the checkboxes for the alarm inputs corresponds to the labeling of the

 

alarm inputs on the VideoJet X20. The motion and video alarm corresponds to the labeling on

 

the video inputs.

 

 

Bosch Security Systems

Installation and Operating Manual

V3.5 2007.12