VideoJet X20Configuration Using a Web Browser en 61

5.22

Alarm Connections

You can select how the VideoJet X20 responds to an alarm. In the event of an alarm, the unit can automatically connect to a pre-defined IP address. You can enter up to ten IP addresses which the VideoJet X20 will contact in order in the event of an alarm, until a connection is made.

5.22.1Connect on alarm

Select On so that the VideoJet X20 automatically connects to a pre-defined IP address in the event of an alarm.

By setting Follows input 1 the unit maintains the connection that has been automatically established for as long as an alarm exists on alarm input 1.

NOTICE!

i By default, Stream 2 is transmitted for alarm connections. Bear this fact in mind when assigning the profile (see Section 5.11 Encoder Profile, page 38).

5.22.2Number of destination IP address

Specify the numbers of the IP addresses to be contacted in the event of an alarm. The unit contacts the remote stations one after the other in the numbered sequence until a connection is made.

5.22.3Destination IP address

For each number, enter the corresponding IP address for the desired remote station.

Bosch Security Systems

Installation and Operating Manual

V3.5 2007.12