Bosch Power Tools 4100DG manual Blade Bevel Control, Extending Table Extension, System Storage

reverse, the guard can be easily removed for special operations such as dados or rabbets.

The Anti-Kickback Device can be easily attached by aligning the attachment pin with the hole in the rear of the riving knife. It can be easily removed by depressing the compression pads on either side of the Anti-Kickback Device and lifting it away.

The Riving Knife can be easily adjusted to one of three heights by removing the table insert, raising the blade to its full height and releasing the riving knife release lever at the base of the Riving Knife. The Riving Knife should be locked in its highest position for use with the Main Barrier Guard and Anti-Kickback Device. It can be adjusted to its middle position for non-through cuts and for use as a material splitter without the Main Barrier Guard and Anti-Kickback Device.

In the event that the Riving Knife can not be used for a specific cut, it can be adjusted to its lowest position, thus placing it 1” above the surface of the table (while the blade is at its full height).

System Storage

1

FIG. 33 2

When not in use, the Main Barrier Guard and Anti-Kickback Device can be stored under the right side table extension.

!	WARNING	Use of all the components of the Smart Guard
		System, including Main Barrier Guard, Anti-

Kickback Device, and Riving Knife is highly recommended to provide protection against accidents and injury.

FIG. 34

4

3

1.Slide the Main Barrier Guard assembly (upside down) up and back into the U-bracket at the rear right side of the saw (Fig. 33).

2.Pivot the rear of the guard up and into the front mounting bracket.

3.Lock the Main Barrier Guard assembly into place in the same manner as you would attach it to the Riving Knife (Fig. 34).

4.Attach the Anti-Kickback Device to the hanging bracket in the same manner that it attaches to the Riving Knife.

Blade Bevel Control

Loosen blade bevel lock handle 1 counterclockwise (Fig. 35), slide the elevation wheel 2 until pointer 3 is at desired angle and tighten blade tilt lock handle 1 clockwise.

Extending Table Extension

To extend the table, raise the table extension lock handle 4 (Fig. 35) and slide table extension 5 to desired width (Fig 36). To secure table setting, lower the lock handle 4.

3 1

FIG. 35

4

2

FIG. 36

5

46.