Non Thru-Sawing
Add 8" high flat facing board to the fence, the full length of the fence (Fig. 66).
Use featherboards for all “Non |
|
|
sawblade guard must be removed). Featherboards 1 are used to |
|
|
FIG. 66 | ||
keep the work in contact with the fence and table as shown, and to |
| WORK |
stop kickbacks. |
| |
|
| SUPPORT |
“C” CLAMPS
1
Mount featherboards 1 to fence and table as shown, so that leading edges of featherboards will support workpiece until cut is complete, and the workpiece has been pushed completely past the cutter (sawblade, dado head, molding head, etc.) with a Push Stick 2, as in ripping.
Before starting the operation (switch saw “OFF” and set cutter below table surface):
A. Install featherboards so they exert pressure on the workpiece;
BE POSITIVE THEY ARE SECURELY ATTACHED.
B. Make sure by trial that the featherboards will stop a kickback if 
one should occur.
Featherboards are not employed during non
REPLACE THE SMART GUARD SYSTEM AS SOON AS THE NON
Rabbeting
SUPPORT
APOYO DE LA
PIEZA DE
TRABAJO
ABRAZADERAS EN “C”
2
1
RABBETING is known as cutting out a section of the corner of a piece of material, across an end or along an edge (Fig. 67).
Making a RABBET requires cuts which do not go all the way through the material. Therefore the Smart Guard System must be removed.
1. Remove blade guard.
FIRST CUT
2. For rabbeting along an edge (long way of workpiece) as shown, |
add facing to rip fence approximately as high as the workpiece is |
wide. Adjust rip fence and blade to required dimensions; then make |
FIG. 67
PREMIÈRE COUPE
PRIMER CORTE
first cut with board flat on table, follow |
cut with workpiece on edge. Follow all precautions, safety |
instructions, and operation instructions as for ripping or rip type |
operations, including featherboards and Push Stick, etc. |
3. For rabbeting across an end, for workpiece |
make the rabbet cut with the board flat on the table. Using the miter |
gauge fitted with a facing, follow the same procedures and |
instructions for crosscutting making successive cuts across the |
width of the workpiece to obtain the desired width of cut. DO NOT |
use the rip fence for rabbeting across the end. |
4. INSTALL SMART GUARD SYSTEM IMMEDIATELY UPON |
COMPLETION OF RABBETING OPERATION. |
Rabbet cuts can also be made in one pass of the workpiece over the cutter using the dado head or molding head.
RABBET
FEUILLURE
REBAJO
SECOND CUT |
|
DEUXIÈME COUPE |
|
SEGUNDO CORTE |
|
RABBETING ALONG | RABBETING ACROSS |
THE EDGE | THE END |
RÉALISATION D’UNE | RÉALISATION D’UNE |
FEUILLURE LE LONG D’UN | FEUILLURE EN TRAVERS |
BORD | D’UNE EXTRÉMITÉ |
Dadoing and Molding
Instructions for operating the Dado and Molding Heads are contained in the booklet furnished with these accessories.
ALWAYS USE APPROPRIATE TABLE INSERT LISTED UNDER ACCESSORIES.
REBAJO A LO LARGO | REBAJO TRANSVERSAL |
DEL BORDE | AL EXTREMO |
76.
