Bosch Digital Carriage
Model DC010
(On Table Saw Model 4100DG-09)
The Bosch Model DC010 Digital Carriage is a precision measuring accessory that is used with the 4100 table saw’s rip fence. The digital carriage will accurately display the distance between the saw’s blade and the working side of the fence before the operator makes a rip cut. The display can be set to show inch (3 mode variations) or metric measurements. The digital information displayed on the carriage is in addition to the analog measurements seen where the fence pointer or table pointer refers to the inch scale on the table saw’s front rail. The 4100 table saw can be preset to make rip cuts without using the digital carriage – see pages
Note: This digital carriage is only used when making rip cuts and should be placed in the left most “parking position” when the saw is used for making other types of cuts.
Features (see figures 37 & 38)
ON/OFF button 2: | turns display ON or OFF. |
UNITS button 3: | sets display’s unit of measurement. |
RESET button 4: | resets the display to a zero |
| measurement. |
LCD Display 5: | displays digital measurements and |
| battery condition. |
Magnets 6: | connects digital carriage to side of |
| fence 9 or parking plate 10. |
Battery cover 7: | (not shown) opens to access 9V battery. |
Connector plate 8: | connects saw’s rip fence 9 to digital |
| carriage 1. |
Parking plate 10: | holds digital carriage 1 when not being |
| used. |
FIG. 37 | 6 |
|
|
|
10 |
| 5 | 6 | |
| 2 | 3 | 4 | 8 |
|
|
|
|
1 7
9
Installing 9 Volt Battery
(see figures 37 & 38) | FIG. 38 |
| |
The digital carriage includes a 9 Volt Alkaline Battery – remove |
|
|
|
the battery from its package. Slide the digital carriage to the |
|
|
|
“parking position” where the left magnet 6 is in contact with the |
|
|
|
parking plate 10. Position the 4100 table saw on its side and |
|
|
|
with the digital carriage resting on the parking plate. Using a |
|
|
|
screwdriver, loosen the screw holding the battery cover 7 (not |
|
|
|
shown) located on the bottom. Remove the cover - the loosened |
|
|
|
|
| DISPLAY TEST | |
screw should remain with the cover. Pull out the wires with the 9 |
|
| |
volt battery connector with snap on endings – connect to new |
|
|
|
battery by firmly pressing the connector on to the battery |
|
|
|
terminals. Put the battery into its container and screw the |
|
|
|
battery cover back in place. |
|
|
|
Note 1: The digital carriage is designed to work best when using a high quality 9 Volt Alkaline Battery.
Note 2: Only when installing a new battery, all graphic segments in the LCD display will turn on (a display test ) for a short period of time (5 seconds), and then the display will change to the 1/16 INCH mode (default mode). The display can be turned off by following the ON/OFF button instructions below or just do nothing for approximately one minute and it will automatically turn off.
48.
