OPERATION
Compressor Operation
You do not have to use the maximum operating pressure at all times because the air tool being used often requires less pressure. Here are general guidelines for setting air pressure.
1.With air compressor engine running and air tank pressurized, attach desired air tool or accessory to quick connect fitting. Use recommended air hose and fitting.
2.Activate air tool, pull Pressure Control knob out, then turn Pressure Control knob clockwise to increase outlet pressure (see Figure 12).
Figure 12 - Pressure Control
Outlet Pressure Gauge | Pressure | |
Control Knob | ||
|
WARNING
Exceeding pressure rating of attachments or inflatables can cause severe injury and/or property damage.
•DO NOT adjust pressure greater than maximum rating of attachments or inflatables.
3.Observe OUTLET PRESSURE GAUGE and adjust pressure to recommended setting of accessory tool.
NOTE:You must adjust outlet air pressure while tool is operating or activated.
4.Push Pressure Control knob in to lock in selected pressure setting.
5.Up to two air hoses and air tools may be connected to the air compressor at the same time. Each will receive air at the same outlet pressure.
Observe these safety precautions when operating air compressor:
WARNING
Hot parts and exhaust gases can exceed 150°F and can cause burns.
•DO NOT touch hot parts and AVOID hot exhaust gases.
•Allow compressor to cool before servicing.
WARNING
Compressed air stream from hose or tank drain can cause soft tissue damage to exposed skin and can propel objects leading to severe injury
and / or property damage.
•DO NOT direct air stream at self or others.
•Always wear ANSI Z87.1 approved safety glasses with side shields.
WARNING
Compressed air is not breathable and can cause bodily injury.
Some paints or solvents may be harmful if inhaled or ingested, causing severe nausea, fainting or poisoning.
•DO NOT use compressed air for breathing.
•Always use NIOSH respirator approved for your application when spraying.
•Read all instructions with respirator so you are certain it will provide necessary protection against inhaling harmful vapors.
WARNING
Starter, pulley, flywheel, belt, and other rotating parts can entangle hands, hair, clothing, or accessories.
•DO NOT operate with protective covers / guards removed or damaged.
•NEVER place hands or body parts inside of running unit.
•DO NOT wear loose clothing, jewelry or anything that may be caught in rotating parts.
•Tie up long hair and remove jewelry.
12
