Assembly

3. Insert retaining pin (B) through hole on axle stud.

Your generator requires some assembly and is ready for use

4.

Slide a wheel (C) over axle stud.

NOTICE Be sure to install wheel with raised hub inboard.

after it has been properly serviced with the recommended oil

5.

Attach wheel to axle stud with a washer (D), lock

and fuel.

If you have any problems with the assembly of your generator,

 

washer (E) and nut (F). Tighten with a 16 mm socket

 

wrench and 19 mm wrench.

please call the generator helpline at 1-800-743-4115. If calling

 

6.

Place hub cap (G) into center of wheel and push until it

for assistance, please have the model, revision, and serial

number from the identification label available. See Generator

 

snaps into place.

Controls and Features for identification label location.

7.

Repeat steps 2 through 6 to secure second wheel.

Unpack Generator

8.

Line up holes in support leg (H) with holes in generator

 

frame.

1. Set the carton on a rigid, flat surface.

 

 

 

2. Remove everything from carton except generator.

 

J

3. Open carton completely by cutting each corner from

 

 

top to bottom.

 

 

4. Leave generator on carton to install wheel kit.

 

 

Shipment Contents

 

 

The generator is supplied with:

 

 

H

•

Engine oil bottles (2)

Reproductionknown to the State of California to cause cancer and

 

for13 mm wren h.

•

Operator’s manual

 

 

K

•

Battery float charger

 

 

 

•

Wheel kit

Not

9.

Attach support leg using 4 capscrews (J) and 4 hex

•

Keys (2)

 

 

nuts (K). Tigh en with a 10 mm socket wrench and

Install Wheel Kit

 

10.

Ret rn generator to normal operating position (resting

NOTICE Wheel kit is not intended for over-the-road use.

 

on wheels).

You will need the following tools to install these

Attach Negative Battery Cable

components:

 

Y ur unit is equipped with electric start capability but can be

•

13 mm and 19 mm wrench

 

 

started manually. If you choose not to use the electric start

• Socket wrench with 10 mm and 16 mm sockets

feature, you do not need to connect the negative battery

 

 

 

Install the wheel kit as follows:

 

cable.

 

The sealed battery on the generator pre–installed except for

1.

Tip generator so that engine side is down.

the negative (black) battery cable.

2.

Slide axle stud (A) through mounting bracket with

 

WARNING Battery posts, terminals and related

 

threaded end facing out.

 

 

 

 

accessories contain lead and lead compounds - chemicals

 

 

 

 

 

C

reproductive harm. Wash hands after handling.

 

B

A

 

 

 

D

 

 

 

 

 

 

 

 

F

 

 

E G

7