Configuring your machine for a wireless network (For
Configure your machine for a wireless network
IMPORTANT
• If you are going to connect your Brother machine to your network, we recommend that you contact your |
|
system administrator prior to installation. You must know your wireless network settings before you |
|
proceed with this installation. | 3 |
•If you have previously configured the wireless settings of the machine, you must reset the network LAN settings before you can configure the wireless settings again. Press Menu, 7, 0 for Network Reset, press 1 for Reset and then choose 1 for Yes to accept the change. The machine will restart automatically.
Using the Setup Wizard from the control panel
You can configure your Brother machine by using the Setup Wizard function. This is located in the Network menu on the machine’s control panel. See to the steps below for further information.
a Write down the wireless network settings of your access point or wireless router. If you do not know them, contact your network administrator or the manufacturer of your access point/router.
Check and record the current wireless network settings.
Network name:(SSID, ESSID)
Communication Mode | Authentication method | Encryption mode | Network key 4 |
Infrastructure | Open system | WEP 2 |
|
|
| NONE | — |
|
|
|
|
| Shared key | WEP 2 |
|
| AES |
| |
|
| TKIP 3 |
|
| LEAP | CKIP |
|
|
|
|
|
| AES |
| |
|
|
|
|
| TKIP |
| |
|
|
| |
|
|
|
|
Open system | WEP 2 |
| |
|
| NONE | — |
|
|
|
|
1
2
The WEP key is for
31