1.2User Mode

Basically, user mode should be accessed by service personnel only. However, if there is demand, you can disclose to end users.

<Procedure>

(1)Check that the front cover is closed.

(2)Turn ON the power switch while holding down the [Go] button. Check that Toner/Drum/Error LEDs are lighted.

(3)Release the [Go] button and check that all LEDs are out.

(4)See accompanying table, press the [Go] button again depending on the necessary number of times.

Each mode starts 2 seconds.

Press the [Go] button

 

Mode

 

 

 

Once

1)

Test Sample Page

 

 

 

Twice

2)

Print Fonts

 

 

 

Three times

3)

USB 2.0 FULL Serial Number Return Value

 

 

Setting

 

 

 

Four times

4)

Hex Dump Mode

 

 

 

Five times

5)

PCB ONLY Mode

 

 

 

Six times

6)

1push Printing Recovery Mode

 

* Check that all LEDs are lighted for one second.

 

 

 

Seven times

7)

Network Reset 1 (APIPA: ON)

 

* Check that all LEDs are lighted for one second.

 

 

 

Eight times

8)

NV-RAM Factory Reset

 

* Check that all LEDs are lighted for one second.

 

 

 

More than nine times

1)

Test Sample Page

 

 

 

CAUTION:

•Each mode starts 2 seconds after pressing the [Go] button.

•If the [Go] button is pressed, the Ready LED is lighted. If the [Go] button is released, the LED is out.

•Pressing of the [Go] button 2 times (Print Fonts) and 7 times (Network Reset 1) is ineffective for HL-2140, and pressing of the [Go] button 2 times or 7 times is printed the (Test Sample page).

5-3

Confidential