Functions of each “User Mode”.
1)Test Sample PageThe machine prints a demo page. The machine returns to the ready status after printing.
2)Print FontsIt is an effective function only for
When the OS used the USB 2.0 FULL in Windows Vista, do not recognize the serial number of USB device depending on a combination of PC and USB device. To avoid this, the return value of serial number can be switched to “0”. It is switched to a set value opposite to a current set value, whenever switching.
The setting change of return value is distinguished by the LED display when the [Go] button is separated. When the Toner LED lights for one second, show that the return value was set from normal value to “0”, and when the Drum LED lights for one second, show that the return value was set from “0” to normal value. The machine automatically goes back to ready state after the setting is completed.
4)Hex Dump ModeThis mode is printed as Hex data. without emulation processing the print data which received from the PC it is used for defectiveness analysis of the transmitted print data.
5)PCB ONLY ModeEven when the engine error occurs and PCB exchange is required for recovery, the machine can be started, ignoring the engine error if this mode is used. NVRAM data can be obtained.
6)1push Printing Recovery ModeDemo page print is possible by pressing [Go] button after the power supply is turned on. The data for printing is cleared since the mode can be executed only once.
This mode enables to recover demo page printing. However, the design of printing is not demo page printing, but test printing.
7)Network Reset 1 (APIPA: ON)It is an effective function only for
The machine is restored to the factory setting and permanent fonts and macros are cleared.
Confidential |