3. Installation
3-2. Installing the motor
Install the motor u to the work table with the four accessory bolts q, cushions w, cushion collars e, flat washers r, spring washers t and nuts y.
At that time, fix by setting bolts q a little to the right of oval hole on motor.
NOTE:
Tighten the nuts so that the clearance between the table and the cushion collars is approximately 1 mm.
Table
1 mm
3-3. Installing the motor pulley
Place the motor pulley q onto the shaft of the motor w so that the key groove is aligned, and then tighten the set screw e so that the center of the V groove in the motor pulley q is aligned as closely as possible with the center of the belt hole in the power table.
8
