10. Adjustment
10-16. Button replacement
10-16-1. Adjustment when the button diameter is changed
■Slide base adjustment
1.Adjust the width of the slide base assembly w to the button width with slide base screw e so that the bottons q pass smoothly.
The bed slide base assembly w can be adjusted for button diameters of 9 to 22 mm.
Adjust so that the clearance between the buttons q and the edge of the slide base assembly w is
2.There are 3 different button upper covers r. The cover for standard button sizes of 9 to 13 mm is factory installed.
To attach buttons from 13 to 22 mm in diameter, loosen screw t and replace cover r (nonstandard accessories).
3.When the button diameter is changed, adjust button stopper A y with the adjusting screws u. Adjust until stopper A y slides into the groove of the upper cover r and comes into contact with the second button (position A).
■Button clamp adjustment
AUTO 1
OFF
AUTO 2
t
0.5mm~1.0mm
1.Loosen step screw q and insert a button into the button clamp w.
2.Lightly tighten step screw q, and remove the button.
3.Close the button clamp w opening 0.5 to 1.0 mm using the plate e.
4.Firmly tighten step screw q.
5.After the button is inserted, push the lever r slightly in the direction of the arrow to check that the trouble indicator t does not blink.
*If the indicator blinks, move slightly and narrow the button clamp w opening (mentioned in 3. above).
47
