10. Adjustment
10-14. Adjusting the vibrating bowl
Gap for double row of buttons
●The vibrating bowl arranges all of the buttons face up and feeds the buttons to the shooter.
●Be sure to readjust the vibrating bowl whenever the buttons are changed.
■If buttons are not fed properly, check the following.
1.Loosen screw w and adjust the gap between the bottom of arm B q and the vibrating bowl so that two buttons can pass.
2.Loosen screw r and adjust the gap between the bottom of arm C e and the vibrating bowl so that one button can pass.
In addition, the arms should topple any standing buttons to assure a smoother flow.
3.Loosen screw y and adjust the gap between the bottom of arm A t and the vibrating bowl so that one button can pass.
4.Loosen bolt i and move selector plate u in or out so that the buttons are aligned face up.
5.Loosen screw !0and adjust the gap between the bottom of height control arm o and the top of the buttons to approximately 0.7 mm.
6.Loosen screw r and adjust the button to button width adjustment arm !1gap to approximately 2 mm so that the buttons are fed to the shooter.
7.If buttons become clogged at the entrance to the shooter, loosen screw !2and turn it so that buttons do not clog at the shooter entrance.
45