Brother LK3-B448E Adjustment 10-16-6. Adjusting the needle location, Horizontal feed position

10. Adjustment

10-16-6. Adjusting the needle location

Adjustment is required whenever the button carrier is replaced.

Make sure the needle is not bent.

■Horizontal feed position

A B	Button hole gap
Needle	Horizontal feed

1.Set the X scale so that the holes A and B in the button are aligned with the point of the needle. (Refer to “Setting the X-scale and Y-scale” on page 45.)

2.Check the positions of the button holes. (Refer to “Checking the sewing pattern” on page 26.)

■Vertical feed position

A~B

C~D

Vertical feed

Button hole gap

AB

A~C

CD

Button hole gap

Horizontal feed

1.Set the Y scale so that the holes A and C in the button are aligned with the point of the needle. (Refer to “Setting the X-scale and Y-scale” on page 45.)

2.Check the positions of the button holes. (Refer to “Checking the sewing pattern” on page 26.)

50

LK3-B448E MARKII/BA-16