Record the outgoing message on your external TAD. Set the TAD to answer calls.

Connections

The external TAD must be connected as shown above.

1 Set your external TAD to one or two rings. (The machine’s Ring Delay setting does not apply.)

2

3

4 Set the Receive Mode to External TAD. (See Choosing the Receive Mode on page 5-1.)

Recording outgoing message (OGM) on an external TAD

Timing is important in recording this message. The message sets up the ways to handle both manual and automatic fax reception.

1 Record 5 seconds of silence at the beginning of your message. (This allows your machine time to listen for the fax CNG tones of automatic transmissions before they stop.)

2 Limit your speaking to 20 seconds.

3 End your 20-second message by giving your Fax Receive Code for people sending manual faxes. For example:

“After the beep, leave a message or send a fax by pressing 51 and Start.”

We recommend beginning your OGM with an initial 5-second silence because the machine cannot hear fax tones over a resonant or loud voice. You may try omitting this pause, but if your machine has trouble receiving, then you must re-record the OGM to include it.

1 - 12 INTRODUCTION