Real Time Transmission

When you are sending a fax, the MFC will scan originals into memory before sending. Then, as soon as the phone line is free, the MFC will start dialing and sending the fax. If memory becomes full, the MFC will send the document in real time (even if REAL TIME TX is set to OFF).

Sometimes you may want to send an important document immediately, without waiting for memory transmission. You can set REAL TIME TX to ON.

1

Place the original face up in the ADF, or face down on the scanner glass.

2

Press Menu, 2, 2, 6.

6.REAL TIME TX

 

 

3To change the default setting,

press or to select ON (or OFF), and then press Set. Go to Step 5

—OR—For the next fax transmission only, press or to select NEXT FAX ONLY, and then press Set.

4For the next fax only, press or to select ON (or OFF), and then press

Set.

5Press 1 if you want to select additional settings. The LCD returns to the SETUP SEND menu—OR—Press 2 if you are finished choosing settings, and then go to Step 6.

6Enter fax number.

7Press Fax Start.

Checking the Jobs Status

Check memory for unsent jobs. (If no memory is clear, the LCD shows NO JOB WAITING.) (See Canceling a Job in Memory, page 6-6.)

1 If the MFC is idle, press Menu, 2, 6.

6.REMAINING JOBS

—OR—

 

If the MFC is busy, press Stop/Exit.

 

2If you have multiple jobs waiting, use or to scroll through the list.

3Press Stop/Exit.

Canceling a Job While Scanning the Original

You can cancel a job while you are scanning it into memory by pressing Stop/Exit. Eject the document by pressing Stop/Exit again.

6 - 5 S E T U P S E N D