Brother PT-7500, PT-7600 Setting bar code parameters, Entering bar code data, Character Symbol

Setting bar code parameters

1Press g, then c.

2Press l or r until the parameter that you wish to change is displayed.

3Press u or d until the desired setting is displayed.

4Repeat steps 2and 3until all parameters are set as you wish.

5Press n.

Entering bar code data

1Press c.

2Type in the new bar code data or edit the old data.

3Press n to add the bar code to the text.

☞To add special characters to the bar code data (only with protocols CODE39, CODABAR, EAN128 or CODE128), position the cursor below the character

immediately to the right of where you wish to add the special character, and then press s. Press u or d until the desired control character is displayed, and then press n to add the character to the data. (Refer to the tables below for a list

of the special characters that are available.)

☞To change the data or WIDTH or UNDER# parameter settings of a bar code that has

already been added to the text, position the cursor below the bar code mark ( ), and then press g, then c.

The following control characters can only be added to bar codes created using protocol

CODE39 or CODABAR.

CODE39

Symbol	Character	Symbol	Character
0	–	4	/
1	.	5	+
2	(SPACE)	6	%
3	$

CODABAR

Symbol	Character	Symbol	Character
0	–	3	/
1	$	4	.
2	:	5	+

24