Brother PT-7600 Problem Cause Solution, Label is not printed, After pressing p, LCD messages are

Problem	Cause	Solution
	Has text been entered?	A label will not print if there is no
		text entered.
	Is the tape cassette installed	Check that the tape cassette is
	correctly, and is there enough tape	installed correctly, and that there is
	remaining?	enough tape remaining.
		If bent, cut the bent section of tape
	Is the end of the tape bent?	with scissors and thread the tape
The label is not printed		through the tape exit slot correctly.
after pressing p.		If jammed, remove the tape
		cassette, carefully pull out the
		jammed tape, and then cut the tape
	Is the tape jammed?	with scissors. Check that the end of
		the tape passes through the tape
		guide, and reinstall the tape
		cassette.
	Is the tape compartment cover	If so, close the tape compartment
	open?	cover correctly.
The LCD messages are		Refer to Changing the
		Language on page 12 and select
displayed in a foreign	Is the language set properly?
		the desired language for the LCD
language.
		messages.
	Is the tape cassette installed	When installing a cassette, press
	correctly?	firmly until it clicks into place.
The label is not printed		If not, clean the print head using a
	Is the print head clean?	cotton swab or optional print head
correctly.		cleaning cassette (TZ-CL4).
	Is the rechargeable battery pack	If the battery indicator comes on,
		charge the rechargeable battery
	charged sufficiently?
		pack.
		If the ink ribbon is broken, replace
		the tape cassette. If not, leave the
		tape uncut and remove the tape
		cassette, then wind the loose ink
		ribbon onto the spool as shown in
		the figure.
The ink ribbon is	Is the ink ribbon in the tape cassette
separated from the ink	loose, or did you pull on the label
roller.	coming out of the tape exit slot?	Spool

		The striped tape indicates you have
	Is there enough tape remaining in	reached the end of the tape. Replace
	the tape cassette?	the tape cassette when the striped
The P-touch labeler stops		tape appears.
while printing a label.
	Are the batteries weak and is the	Replace all batteries or connect the
		AC adapter directly to the P-touch
	AC adapter disconnected?
		labeler.

Appendix

75