Bryant 580D manual Base Unit Dimensions Ð 579F240,300

BASE UNIT DIMENSIONS Ð 579F240,300

NOTES:

1.Dimensions in ( ) are in millimeters.

2. Center of gravity.

3. Direction of air¯ow.

4.Ductwork to be attached to accessory roof curb or adapter only.

5.Minimum clearance:

a.Rear: 7 0 (2134) for coil removal. This dimension can be reduced to 4 0 (1219) if conditions permit coil removal from the top.

b.4 0 (1219) to combustible surfaces, all four sides (includes between units).

c.Left side: 4 0 (1219) for proper condenser coil air¯ow.

d.Front: 4 0 (1219) for control box access.

e.Right side: 4 0 (1219) for proper operation of damper and power exhaust (if so equipped).

f.Top: 6 0 (1829) to assure proper condenser fan operation.

g.Bottom: 14 (356) to combustible surfaces (when not using curb or adapter).

h.Control box side: 3 0 (914) to ungrounded surfaces (non-combustible).

i.Control box side, 3 6 (1067) to block or concrete walls, or other grounded surfaces.

j.Local codes or jurisdiction may prevail.

6.With the exception of clearance for the condenser coil and the damper/power exhaust as stated in Note No. 5,

aremovable fence or barricade requires no clearance.

7.Dimensions are from outside of corner post. Allow 0 -5¤16(8) on each side for top panel drip edge.

8.Do not locate adjacent units with the discharge facing economizer inlet.

UNIT				CORNER WEIGHT*									DIMENSION
		A		B				C			D			X
579F
	lb		kg	lb	kg		lb		kg	lb		kg	ft-in.		mm
240	520		235	508		230	532		241	640		290	3-2		965
300	527		239	545		247	578		262	600		272	3-7		1092

*Weights are for unit only (aluminum plate ®ns) and do not include op- tions or crating.

20