9E312/9E423 Module Bridging

Changing Bridge Spanning Tree Parameters

The Bridge Spanning Tree window allows you to update the following parameters for your 9E312/9E423 Module bridge. When you have finished making changes to the following individual parameters, you must click on

at the bottom of the Spanning Tree window to write the changes to the

device.

NOTE

Any values you set at the bridge will cause a Topology Change flag to be issued in the next Configuration BPDUs it transmits. This will cause the bridged network to immediately recalculate Spanning Tree and change topology accordingly.

Changing Bridge Priority

To change the part of the bridge address that contains the identifier used in the Spanning Tree Algorithm for priority comparisons:

1.Highlight the Bridge Priority field.

2.Enter the new identifier, in hexadecimal format; the allowed range is 0-FFFF hexadecimal.

3.Click on .

The selected Bridge Priority will be applied to the bridge (a lower number indicates a higher priority in the root selection process).

Changing the Spanning Tree Algorithm Protocol Type

To change the type of protocol used in Spanning Tree:

1.Click the mouse on the appropriate option button: 802.1, DEC, or NONE.

2.Click on .

!

CAUTION

The selected Spanning Tree Algorithm protocol type will be applied to the bridge. If you selected None, the Spanning Tree Algorithm will be disabled (if it already was enabled). If STA Protocol Type was changed from None to IEEE 802.1 or DEC, you must restart the bridge for the newly selected STA protocol to be applied.

All bridges in a network should use the same Spanning Tree version. Mixing Spanning Tree Algorithm protocols will cause an unstable network.

Bridge Spanning Tree

3-17

Page 52
Image 52
Cabletron Systems 9E423, 9E312 manual Changing Bridge Spanning Tree Parameters, Changing Bridge Priority