Cabletron Systems SM-CSI1076, 1088, 1082 manual Introduction, AutoDiscovery vs. Manual Modeling

Models: 1082 1088 SM-CSI1076

1 69
Download 69 pages 59.11 Kb
Page 60
Image 60
Modeling

M o d e l i n g

Modeling

This section describes how to manually model a 6C105 chassis and a SmartSwitch 6000 module installed in the chassis and place the resulting device icons in their proper SPECTRUM views.

Introduction

The following topics are covered in this section:

AutoDiscovery vs. Manual Modeling (page 61)

Manual Modeling Overview (page 62)

Preparation for Modeling (page 63)

Modeling Using the Chassis IP (page 63)

Positioning the Chassis Device Icon (page 66)

AutoDiscovery vs. Manual Modeling

SPECTRUM’s AutoDiscovery is recommended if you are modeling a network for the first time or want to discover and model a network segment after making changes to it.

AutoDiscovery is not recommended for use when the SmartSwitch 6000 is in Mixed Management mode, see Management Modes (page 9).

Autodiscovery involves manually modeling a seed router, bridge, or switch (if such a model does exist) and then running AutoDiscovery one or more times to complete the network model. You then refine your autodiscovered network model to improve management capabilities.

Refer to Getting Started with

SPECTRUM for Administrators and

Note:t : How to Manage Your Network with SPECTRUM for instructions on using

AutoDiscovery and refining your network model.

The manual modeling procedures described in this section should be used when making minor changes to the network. This includes such actions as placing an already discovered module in Mixed Management mode or adding a new chassis or module to the network.

S p e c t r u m E n t e r p r i s e M a n a g e r

Page 61

S m a r t S w i t c h 6 0 0 0

Page 60
Image 60
Cabletron Systems SM-CSI1076 Introduction, AutoDiscovery vs. Manual Modeling, Positioning the Chassis Device Icon page