Cause | Action | |
The machine is not connected properly. | Make sure that the USB cable is securely plugged in to the machine and the | |
|
| computer. |
|
| z If you are using a relay device such as a USB hub, disconnect it, connect the |
|
| machine directly to the computer, and try printing again. If printing starts |
|
| normally, there is a problem with the relay device. |
|
| Consult the reseller of the relay device for details. |
|
| z There could also be a problem with the USB cable. Replace the USB cable |
|
| and try printing again. |
|
| When you use the machine over LAN, make sure that the machine is connected |
|
| to the network with a LAN cable and is set up correctly. Refer to “Checking |
|
| Information about the Network” in the User’s Guide |
Your machine is not selected in Printer | Select your machine’s name in Printer on the Print dialog box. | |
on the Print dialog box. | If your machine’s name does not appear in Printer, follow the procedure below | |
|
| to check that the driver for your machine is installed to your computer. |
|
| (1)Select Print & Fax Preferences in Printer. |
|
| In Mac OS X v.10.2.8 or 10.3.x, select Edit Printer List in Printer. |
|
| (2)Check that your machine’s name is displayed in the list of printers and that |
|
| the check box is selected. |
|
| In Mac OS X v.10.2.8, check that your machine’s name is displayed in |
|
| Printer List. |
|
| (3)If your machine’s name is not displayed, click Add(+) to add the machine. |
|
| If you cannot add the machine, follow the procedure described in your setup |
|
| sheet or the Network Setup Guide to reinstall the MP Drivers. |
|
|
|
|
|
|
Error No.: 1700/1710 Is Displayed
Cause | Action | |
The ink absorber is almost full. | See ““The waste ink absorber is almost full. Press [OK] to continue but early | |
|
| replacement recommended. <See manual>”” on page 102. |
|
|
|
|
|
|
Error No.: 2001 Is Displayed
Cause | Action | |
No response from connected digital | See ““Incompatible device detected. Remove the device.”” on page 102. | |
camera or video camcorder. / |
| |
Connected digital camera or video |
| |
camcorder is not compatible with this |
| |
machine. |
| |
|
|
|
|
|
|
Error No.: 2002 Is Displayed
Cause | Action |
PictBridge compliant device is | See ““An unsupported USB hub is connected. Remove the hub.”” on page 102. |
connected via a USB hub. |
|
Troubleshooting 119