Carrier 69NT20-531-300 manual DataCORDER Alarm Indications

	Table 3-10 DataCORDER Alarm Indications
		To Access: Press ALT. MODE key
Code No.	TITLE	DESCRIPTION
		The supply recorder sensor reading is outside of the range of -50_C to
	Recorder Supply	70_C (-58_F to +158_F) or, the probe check logic has determined there is
		a fault with this sensor.
dAL70	Temperature Out of
	Range	NOTE
		The P5 Pre-Trip test must be run to inactivate the alarm.
		The return recorder sensor reading is outside of the range of -50_C to
		70_C (-58_F to +158_F) or, the probe check logic has determined there is
dAL71	Recorder Return Tem-	a fault with this sensor.
	perature Out of Range
		NOTE
		The P5 Pre-Trip test must be run to inactivate the alarm.
dAL72-74	USDA Temperatures	The USDA probe temperature reading is sensed outside of -50 to 70°C
	1, 2, 3 Out of Range	(-58 to 158°F) range.
dAL75	Cargo Probe 4 Out of	The cargo probe temperature reading is outside of -50 to 70°C (-58 to
	Range	158°F) range.
dAL76, 77	Future Expansion	These alarms are for future expansion, and are not in use at this time.
		The network data point is outside of its specified range. The DataCORD-
		ER is configured by default to record the supply and return recorder sen-
dAL78-85	Network Data Point	sors. The DataCORDER may be configured to record up to 8 additional
		network data points. An alarm number (AL78 to AL85) is assigned to
	1 - 8 Out of Range
		each configured point. When an alarm occurs, the DataCORDER must be
		interrogated to identify the data point assigned. When a humidity sensor is
		installed, it is usually assigned to AL78.
dAL86	RTC Battery Low	The Real Time Clock (RTC) backup battery is too low to adequately
		maintain the RTC reading.
		An invalid date or time has been detected. This situation may be corrected
dAL87	RTC Failure	by changing the Real Time Clock (RTC) to a valid value using the Data-
		View.
dAL88	DataCORDER	A write of critical DataCORDER information to the EEPROM has failed.
	EEPROM Failure
dAL89	Flash Memory Error	An error has been detected in the process of writing daily data to the non-
		volatile FLASH memory.
dAL90	Future Expansion	This alarm is for future expansion, and is not in use at this time.
dAL91	Alarm List Full	The DataCORDER alarm queue is determined to be full (eight alarms).

3-27 T-309