Chapter 3 Avaya P460 Chassis and Module Installation
Required Tools
You require the following equipment in order to install the P460 chassis:
•Phillips
Environmental Prerequisites
Danger: To avoid injury, Avaya recommends that two people lift the switch onto a table top. A fully loaded P460 switch weighs at least 100 lbs (45 kg).
You can position the Avaya P460 in
When deciding where to position the chassis, ensure that:
•It is accessible and cables can be connected easily and according to the configuration rule.
•Cables are away from sources of electrical noise such as:
—radio transmitters
—broadcast amplifiers
—power lines
—fluorescent lighting fixtures.
•Water or moisture cannot enter the case of the chassis.
•There is a free flow of air around all sides the chassis.
•The vents on the sides of the case are not blocked.
•The table or shelf can hold the weight of the chassis with the PSUs and modules.
•The environmental conditions match the requirements listed in Table 3.1. See Chapter 15, “Specifications“ for additional information.
Table 3.1 | Environmental Requirements | |
|
| |
Ambient temperature | 23o to 122oF | |
Relative humidity | 5% to 95%, non condensing | |
|
| |
Minimum clearance for | 2" (5 cm) on each side | |
ventilation |
|
|
|
| |
Weight support | 50 lb. (23 kg) to 100 lbs (45 kg) | |
|
|
|
4 | Avaya P460 Installation and Maintenance Guide |
