Cisco Systems 3560-C manual 77 in .49 cm 72 in .44 cm 46. 62 in .19 cm Switch

Chapter 2 Switch Installation

Mounting the Switch

Step 1 Locate the screw template. The template is used to align the mounting screw holes.

Note Figure 2-5shows the measurements for the location of the screws on the switch.

Step 2 Position the screw template so that the two side-by-side slots face toward the floor, as shown in Figure 2-6.

For the best support of the switch and cables, make sure that you attach the switch securely to a wall stud or to a firmly attached plywood mounting backboard.

Step 3 Peel the adhesive strip off the bottom of the screw template.

Step 4 Attach the screw template to the wall.

Step 5 Use a 0.144-inch (3.7 mm) or a #27 drill bit to drill a 1/2-inch (12.7 mm) hole in the three screw template slots.

Step 6 Insert three screws in the slots on the screw template, and tighten until they touch the top of the screw template.

Step 7 Remove the screw template from the wall.

Figure 2-5 Location of the Mounting Holes on the Switch

6

5

4

1 2 3

330380

		1	1.77 in. (4.49 cm)		4	2.67 in. (6.78)
2			3.72 in. (9.44 cm)		5	2.46. in. (6.24)
3			3.62 in. (9.19 cm)		6	Switch
				Catalyst 3560-C and 2960-C Switch Hardware Installation Guide
	OL-23803-02						2-11