Cisco Systems 3560-C manual After Installing the Switch, Installing SFP Modules, 2-31

Chapter 2 Switch Installation

After Installing the Switch

Step 5 (Optional) To attach the cable guard to the desk or wall, use a 0.144-inch (3.7 mm) or a #27 drill bit to drill 1/2-inch (12.7 mm) holes at each of the two mounting locations. Insert the supplied 0.5 in.

(12.7 mm) number-8 Phillips wood screws and tighten them as shown in Figure 2-33.

Figure 2-33 Securing the Cable Guard to the Desk

1 1

1

208919

2

Number-8 Phillips wood screws 2 Desk or shelf

After Installing the Switch

1.Power on the switch. See the “Verifying Switch Operation” section on page 2-5.

2.Connect to a 10/100 or 10/100/1000 port, and run Express Setup. See the switch getting started guide for instructions.

3.Connect to the ports. See the “Connecting Devices to the Ethernet Ports” section on page 2-33to complete the installation.

For configuration instructions about using the CLI setup program, go to Appendix C, “Configuring the Switch with the CLI Setup Program.”

Installing SFP Modules

When installing SFP modules, observe these guidelines:

•Removing and installing an SFP module can shorten its useful life. Do not remove and insert any module more often than is absolutely necessary.

•To prevent ESD damage, follow your normal board and component handling procedures when connecting cables to the switch and other devices.

	Catalyst 3560-C and 2960-C Switch Hardware Installation Guide
OL-23803-02		2-31