Cisco Systems 3800 Series Installing a Pvdm, Tilt Pvdm up to vertical Clips snap into place

PVDM Installation and Removal

Figure 64 PVDM Polarization Notch

103363

Polarization notch

Alignment holes

Installing a PVDM

To install a PVDM, follow these steps:

Note Install PVDMs beginning with the PVDM 0 connector.

Step 1 Locate the PVDM connector on the motherboard. See Figure 51 and Figure 52 for PVDM connector locations.

Step 2 Orient the PVDM so that the polarization notch lines up with the key on the connector. See Figure 64.

Step 3 Hold the PVDM at an angle and insert it carefully into the PVDM connector. Tilt the PVDM up to the vertical position so that the clips snap into place at both ends. See Figure 65.

Figure 65 Installing a PVDM

2

1

2

103469

1

Tilt PVDM up to vertical

2

Clips snap into place

Installing and Upgrading Internal Components in Cisco 3800 Series Routers

OL-5975-04 97