Cisco Systems 700 manual Ipcp Description, Ipcp Address Negotiation Application Notes

IPCP Description

IPCP Description

If you are using IP routing, Cisco 700 series routers must be configured for IPCP to connect to routers running Cisco IOS software. Use the set ip framing command in profile mode to enable IPCP for user-defined WAN profiles by setting IP framing to none.

The following example illustrates IPCP enabled by disabling IP framing:

766:2503> set ip framing none

Note Do not set the ip framing or the ipx framing commands to none when configuring the permanent LAN profile.

IPCP Address Negotiation Application Notes

The following are application notes for IPCP address negotiation:

•Cisco 700 series routers require a user-defined profile, configured with IP routing on, to receive an IPCP addresses.

•A router running Cisco IOS software must be configured to hand off IPCP addresses.

•If a manually configured IP address exists on the Internal profile of a Cisco 700 series router, the IPCP address is assigned to the WAN profile.

•If a manually configured IP address exists on the LAN profile, the IPCP address is assigned to the Internal profile.

5-4Cisco700 Series Router Configuration Guide