Chapter3 Installing the Cisco 7609 Internet Router
Installing the Cisco 7609 Chassis in the Rack
3-8
Cisco7609 Internet Router Installation Guide
OL-5079-04
Installing the Cisco 7609 Chassis in the Rack
Note If you are not installing the Cisco 7609 Internet Router in t he rack, you must
install the stabilizer kit. See “Installing the Stabilizer Kit” section on
page 3-10.
Caution Mount the chassis in the rack before installing the power supplies or line cards.
You are now ready to install the Cisco 7609 chassis in the rack.
Tip We recommend that you have a third person to assist in this procedure.
Warning
Two people are required to lift the empty chassis. Grasp the chassis
underneath the lower edge and lift with both hands. To prevent injury, keep
your back straight and lift with your legs, not your back.
To install the Cisco 7609 chassis in the equipment rack, perform these steps:
Step 1 With a person standing at each side of the chassis, grasp the chassis handle with
one hand and use the other hand near the back of the chassis for balance. Slowly
lift the chassis in unison. Avoid sudden twists or moves to prevent injury.
Step 2 Position the chassis in the rack as follows. (See Figure3-4.)
a. If the front of the chassis (front panel) is at the front of the rack, insert the
rear of the chassis between the mounting posts.
b. If the rear of the chassis is at the front of the rack, insert the front of the
chassis between the mounting posts.
Step 3 Rest the chassis on the shelf brackets and crossbar bracket.
Step 4 Align the mounting holes in the Lbracket with the mounting holes in the
equipment rack.