Cisco Systems 7609 manual Supervisor Engine Console Port Connector

Chapter 3 Installing the Cisco 7609 Internet Router

Attaching the Interface Cables

Figure 3-7 Supervisor Engine Console Port Connector

WS-X6K-SUP1
STATUS SYSTEM ACTIVE PW	LIGHT
	RESET
R

SUPERVISOR I

CONSOLE

PORT

MODE

CONSOLE

48127

Note The accessory kit that shipped with your Cisco 7609 Internet Router contains the necessary cable and adapters to connect a terminal or modem to the console port.

To connect a terminal to the console port using the cable and adapters provided, perform these steps:

Step 1 Place the console port mode switch in the in position (factory default).

Step 2 Connect to the port using the RJ-45-to-RJ-45 cable and RJ-45-to-DB-25 DTE adapter or RJ-45-to-DB-9 DTE adapter (labeled “Terminal”).

Step 3 Position the cable in the cable guide (if installed). Make sure that there are no sharp bends in the cable.

Step 4 Check the terminal documentation to determine the baud rate. The baud rate of the terminal must match the default baud rate (9600 baud) of the console port. Set up the terminal as follows:

•9600 baud

•8 data bits

•No parity

•2 stop bits

	Cisco 7609 Internet Router Installation Guide
3-16	OL-5079-04