3-7
Cisco AS5350 Universal Gateway Chassis Installation Guide
78-10754-03 0A
Chapter3 Installing the CiscoAS5350 Connecting to the Network
Caution If the universal gateway is configured with fewer than three DFCs, make sure that a blank slot cover is
installed over each open s l ot to ensure proper air fl ow.
Note The CiscoAS5350 arrives with all carrier cards and DFCs already installed, unless you order a card
separately as a spare. Refer to the Cisco AS5350 Universal Gateway Card Installation Guide for card
installation instructions. This document is available on C isco.com and the document ation CD-ROM that
comes with your universal ga teway. (See the “Obtaining Documentation” section on page xiii .)
Connecting to an Ethernet NetworkConnect an CiscoAS5350 Fast Ethernet port to an Ethernet hub using a straight-through,
RJ-45-to-RJ-45, Et he rnet cable. (See Fi gu re 3-7.)
Figure3-7 Connecting to an Ethernet Hub (10/100BASE-T Shown)
Connecting to a WANWarning
To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord. To see
translations of the warnings that appear in the publication, refer to the Regulatory Compliance and
Safety Information document that accompanied this device.
Warning
This equipment is to be installed and maintained by service personnel only as defined by AS/NZS3260
Clause 1.2.14.3 Service Personnel. To see translations of the warnings that appear in the publication,
refer to the Regulatory Compliance and Safety Information document that accompanied this device.
35670
871
Ethernet hub
Straight-through
Ethernet cable
FE1
10/100BASE-T port
(RJ-45)