3-11
Cisco AS5350 Universal Gateway Chassis Installation Guide
78-10754-03 0A
Chapter3 Installing the CiscoAS5350 Connecting to the Console and Auxiliary Ports
•Connect a synchronous serial port to a modem or a CSU/DSU with a serial transition cable. (See
Figure3-12.)
Figure3-12 Connecting to a CSU/DSU
Connecting to the Console and Auxiliary Por ts
Use the console terminal for lo cal administrative access to the universal gateway. You can only connect
a terminal to the console por t. You can use the auxiliary port to conn ect a terminal or a modem for remote
access to the universal gateway.

Connecting to the Console Port

To connect a terminal (an ASCII ter mi nal or a PC running term in al em u la tio n software) to the console
port on the CiscoAS5350, follow this procedure:
Step 1 Connect the terminal to the console port using an RJ-45 rollover cable and an RJ-45-to-DB-25 or
RJ-45-to-DB-9 adapter. The adapters prov id ed ar e lab el ed TE RMINAL. The adapters and the roll over
cable are included in the acces so r y ki t t ha t c om es with the universal gateway. (See Figure 3-13 .)
Note For additional information on rollov er cabl e pinou ts, see Append ixC, “Cabling Specifications. ”
Step 2 Configure your terminal or PC terminal emulation software for 9600 baud, 8data bits, no parity, and
2 s top bi ts.
Step 3 Configure the console port. See the CiscoAS5350 and Cisco AS5400 Universal Gateway Software
Configuration Guide. This document is available on the World Wide Web and the documentation
CD-ROM that comes with your universal gateway. (See the “Obtaining Documentat ion” section on
page xiii.)
35675
Serial
transition
cable
CSU/DSU or
other DCE or DTE
Synchronous serial
port (DB-26)
EIA/TIA-232, EIA/TIA-449, EIA/TIA-530A,
EIA/TIA-530, V.35, or X.21 connector
Internet