Cisco Systems BC-109 manual Configure LNM Support, Netbios name-cache query-timeout seconds

Configure LNM Support

The Cisco IOS software also converts pairs of FIND_NAME and NAME_RECOGNIZED packets received from explorers, which traverse all rings, to specific route frames that are sent only between the two machines that need to see these packets.

You can specify a query-timeout, or “dead-time” interval to prevent repeat or duplicate broadcast of these type of packets for the duration of the interval.

To specify dead time intervals, use one or both of the following commands in global configuration mode:

Command	Purpose
netbios name-cache query-timeout seconds	Specify a dead time interval during which the
	Cisco IOS software drops any broadcast
	(NetBIOS ADD_NAME_QUERY,
	ADD_GROUP_NAME, or STATUS_QUERY)
	frames if they are duplicate frames sent by the
	same host.
netbios name-cache recognized-timeout seconds	Specify a dead time interval during which the
	software drops FIND_NAME and
	NAME_RECOGNIZED frames if they are
	duplicate frames sent by the same host.

Configure LNM Support

LAN Network Manager (LNM), formerly called LAN Manager, is an IBM product for managing a collection of source-route bridges. Using either a proprietary protocol or the Simple Network Management Protocol (SNMP), LNM allows you to monitor the entire collection of Token Rings that comprise your source-route bridged network. You can use LNM to manage the configuration of source-route bridges, monitor Token Ring errors, and gather information from Token Ring parameter servers.

Note LNM is supported on the 4/16-Mb Token Ring cards that can be configured for either 4- or 16-Mb transmission speeds. LNM support is not provided on CSC-R16M cards with SBEMON 2.0.

LNM is not limited to managing locally attached Token Ring networks; it also can manage any other Token Rings in your source-route bridged network that are connected through non-Token Ring media. To accomplish this task, LNM works in conjunction with the IBM Bridge Program. The IBM Bridge Program gathers data about the local Token Ring network and relays it back to LNM. In this manner, the bridge program becomes a proxy for information about its local Token Ring. Without this ability, you would require direct access to a device on every Token Ring in the network. This process would make managing an SRB environment awkward and cumbersome.

Figure 51 shows some Token Rings attached through a cloud and one LNM linking to a source-route bridge on each local ring.

BC-126Bridging and IBM Networking Configuration Guide