Chapter 5 ROM Monitor Overview and Basic Procedures

Exiting ROM Monitor Mode

HDD Status

:

0A30

MEFW Version

:

6.0.50.1244

System Straps

:

00000F00 BE036FF1 B2EB6E8F

Hardware Anchor :

F01001R06.0116f365a2012-07-17

Certificate

:

946944F17906C95E

Microloader

:

MA0001R04.013eb9f7f2012-06-22

Module 0/1

:

Absent

Module 0/2

:

Absent

Module 0/3

:

Absent

Module 0/4

:

Absent

Module 1/0

:

Absent

Module 2/0

:

Absent

PCH Enum Errs

:

0

Entering Environment Variable Settings

Environment variable settings are entered in capital letters, followed by a definition. The following example shows the environmental variables used to configure the control Ethernet port on a Cisco ISR 4451-X:

rommon > IP_ADDRESS=1.1.1.1

rommon > IP_SUBNET_MASK=255.255.254.0

rommon > DEFAULT_GATEWAY=1.1.0.1

Saving Environment Variable Settings

To save the current environment variable settings, enter the sync command:

rommon > sync

Note Environmental values that are not saved with the sync command are discarded whenever the system is reset or booted.

Exiting ROM Monitor Mode

To exit ROM Monitor mode, you must change the configuration register and reset the .

SUMMARY STEPS

1.confreg

2.Respond to each prompt as instructed.

3.reset

Hardware Installation Guide for the Cisco 4451-X Integrated Services Router

5-7

Page 113
Image 113
Cisco Systems ISR4451XK9 manual Exiting ROM Monitor Mode, Entering Environment Variable Settings