Cisco Systems ISR4451XK9 manual Removing the NIM-SSD from the Router

Chapter 6 Installing and Upgrading Internal Modules and FRUs

Overview of the SSD Carrier Card NIM (NIM-SSD)

Warning During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94

Before you begin, read the following important notices:

•The form-factor internal hard drive is accessible from the front panel of the Cisco ISR 4451-X and supports the online insertion and removal feature (OIR) using the following CLI commands for the standby and active RP2:

–request platform hardware filesystem harddisk: offline (Unmounts the hard disk on the active RP2.)

–To verify once the SSD drive is installed in the router, use the show platform command. The following example shows a sample output for a NIM SSD installed:

Router# show platform

Chassis type: ISR4451/K9

Slot	Type	State	Insert time (ago)
---------	-------------------	---------------------	-----------------
0	ISR4452/K9	ok	15:57:33
0/0	ISR4451-6X1GE	ok	15:55:24
g0/3	NIM-SSD	ok	15:55:24
1	ISR4451/K9	ok	15:57:33
1/0	SM-1T3/E3	ok	15:55:24
2	ISR4451/K9	ok	15:57:33
2/0	SM-1T3/E3	ok	15:55:24
R0	ISR4451/K9	ok, active	15:57:33
F0	ISR4451-FP	ok, active	15:57:33
P0	Unknown	ps, fail	never
P1	XXX-XXXX-XX	ok	15:56:58
P2	ACS-4450-ASSY	ok	15:56:58
Slot	CPLD Version	Firmware Version
---------	-------------------	---------------------------------------
0	12090323	15.3(01r)S	[ciscouser-ISRRO...
1	12090323	15.3(01r)S	[ciscouser-ISRRO...
2	12090323	15.3(01r)S	[ciscouser-ISRRO...
R0	12090323	15.3(01r)S	[ciscouser-ISRRO...
F0	12090323	15.3(01r)S	[ciscouser-ISRRO...

•The reason you would be removing an internal hard drive is that it is failing or failed; so any data recovery may be lost.

•If the drive is functioning, you can back it up to a drive plugged into a USB port using the archive tar command.

Removing the NIM-SSD from the Router

To remove the SSD NIM from the Cisco ISR 4451-X, follow this procedure:

Step 1 Slip on the ESD-preventive wrist strap that was included in the accessory kit. Loosen the screw fasteners

(11)located on the SSD slots on the right of the input/output (I/O) side of the Cisco ISR 4451-X. (Figure 6-12).

	Hardware Installation Guide for the Cisco 4451-X Integrated Services Router
OL-27644-01		6-16