Chapter 6 Installing and Upgrading Internal Modules and FRUs

Accessing Internal Modules

Accessing Internal Modules

To access the internal modules on the router., you must first remove the chassis cover. See the Removing and Replacing the Chassis Cover, page 6-4for instructions on how to remove and later replace the chassis cover on the Cisco ISR 4451-Xs.

Removing and Replacing the Chassis Cover

The Cisco ISR 4451-Xs have a removable cover.

Caution Do not run the router with the cover off. Doing so can cause the router to overheat very quickly.

Warning Before opening the unit, disconnect the telephone-network cables to avoid contact with telephone-network voltages. Statement 1041

Note Use a number-2 Phillips screwdriver to perform the following tasks.

Removing the Cover

To remove the cover, perform the following steps.

Step 1 Read the “Safety Warnings” section on page 6-2and disconnect the power supply before you perform any module replacement.

Step 2 Confirm the router is turned off and disconnected from the power supply or power supplies. If a redundant power is used, disconnect from the redundant power supply.

Step 3 Place the chassis on a flat surface.

Step 4 Remove the three cover screws at the back of the router cover. See Figure 6-1.

Step 5 Lift the cover from the back edge to a 45-degree angle.

Step 6 Pull the cover toward you to disengage the slots along the front (bezel) edge of the chassis. See Figure 6-1.

Replacing the Cover

To replace the cover, perform the following steps.

Step 1 Read the Safety Warnings, page 6-2and disconnect the power supply before you perform any module replacement.

Step 2 Confirm the router is turned off and disconnected from the power supply or power supplies. If a redundant power is used disconnect from the redundant power supply.

Step 3 Place the chassis on a flat surface.

Hardware Installation Guide for the Cisco 4451-X Integrated Services Router

 

OL-27644-01

6-4

 

 

 

Page 120
Image 120
Cisco Systems ISR4451XK9 manual Accessing Internal Modules, Removing and Replacing the Chassis Cover, Removing the Cover