Cisco Systems ISR4451XK9 manual Removing a Dimm

Chapter 6 Installing and Upgrading Internal Modules and FRUs

Installing and Removing DDR DIMMs

Removing a DIMM

Follow these steps to remove a DIMM:

Step 1 Read the “Safety Warnings” section on page 6-2section and disconnect the power supply before you perform any module replacement.

Step 2 Remove the chassis cover. For Cisco ISR 4451-Xs, see the “Removing and Replacing the Chassis Cover” section on page 6-4.

Step 3 Locate the DIMM module. See the “Locating Internal and External Slots for Modules” section on page 6-5to find the DIMM sockets on the router.

Step 4 Pull the latches away from the DIMM at both ends to lift the DIMM slightly. Pull the DIMM out of the socket as shown in Figure 6-15.

Figure 6-15 Removing a DIMM

250945

Step 5 Place the DIMM in an antistatic bag to protect it from ESD damage.

Step 6 Replace the chassis cover. For Cisco ISR 4451-Xs, see the “Removing and Replacing the Chassis Cover” section on page 6-4. .

	Hardware Installation Guide for the Cisco 4451-X Integrated Services Router
OL-27644-01		6-20