Cisco Systems ISR4451XK9 You are now in the Setup Configuration Utility, Shown as examples only

Chapter 4 Initial Configuration

Performing the Initial Configuration on the Router

Step 1	From the Cisco IOS-XE CLI, enter the setup command in privileged EXEC mode:
		Router> enable
		Password: <password>
		Router# setup
			--- System Configuration Dialog ---
		Continue with configuration dialog? [yes/no]:
		You are now in the Setup Configuration Utility.
		The prompts in the setup command facility vary; depending on your router model, on the installed
		interface modules, and on the software image. The following steps and the user entries (in bold) are
		shown as examples only.
	Note		This setup command facility is also entered automatically if there is no configuration on the
			router when it is booted into Cisco IOS-XE.
	Note		If you make a mistake while using the setup command facility, you can exit and run the setup
			command facility again. Press Ctrl-C, and enter the setup command at the privileged EXEC
			mode prompt (Router#). For more information on using the setup command facility, see The
			Setup Command chapter in Cisco IOS Configuration Fundamentals Command Reference,
			Release 12.2T, at the following URL:
			http://www.cisco.com/en/US/docs/ios/12_2t/fun/command/reference/122tfr.html
Step 2	To proceed using the setup command facility, enter yes.
		Continue with configuration dialog? [yes/no]:
		At any point you may enter a question mark '?' for help.
		Use ctrl-c to abort configuration dialog at any prompt.
		Default settings are in square brackets '[]'.
Step 3	Basic management setup configures only enough connectivity
	Would you like to enter basic management setup? [yes/no]: yes
Step 4	Enter a hostname for the router (this example uses myrouter):
	Configuring global parameters:
	Enter host name [Router]: myrouter
Step 5	Enter an enable secret password. This password is encrypted (for more security) and cannot be seen
	when viewing the configuration.
	The enable secret is a password used to protect access to
	privileged EXEC and configuration modes. This password, after
	entered, becomes encrypted in the configuration.
	Enter enable secret: cisco
Step 6	Enter an enable password that is different from the enable secret password. This password is not
	encrypted (and is less secure) and can be seen when viewing the configuration.
	The enable password is used when you do not specify an
	enable secret password, with some older software versions, and
	some boot images.
	Enter enable password: cisco123
			Hardware Installation Guide for the Cisco 4451-X Integrated Services Router
OL-27644-01				4-2