Setup (Main Unit)

Connections!

1

Connect the telephone line cord.

2

Connect the power cord.

¡When the power is turned on for the first

time, the unit will print an information list about the starter film.

Power socket

Power cord

Connect to

Power outlet “LINE”.

(120 V, 60 Hz)

Power surge ( protector )

Single telephone line

 

LINE

(RJ11C)

 

 

Telephone line cord

( protectorLine surge

)

 

Note:

¡When the telephone line cord and power cord are connected, the unit will start detecting the dialing mode.

¡Display: CHECKING LINE

¡Wait until one of the following messages is displayed. ¡—If your line has touch tone service,

LINE IS TONE

¡—If your line has rotary pulse dial service,

LINE IS PULSE

¡If the power cord is disconnected or a power failure occurs, the unit will detect the dialing mode again when power is restored.

¡You can change the dialing mode setting manually. See “Setting the dialing mode” on page 42.

¡If you connect the power cord before connecting the telephone line cord, the following messages will be shown alternately.

Display: CONNECT TEL LINE TEL LINE IS OPEN

Connect the telephone line cord.

¡For additional equipment protection, we recommend the use of a surge protector. The following types are available; TELESPIKE BLOK MODEL TSB (TRIPPE MFG. CO.), SPIKE BLOK MODEL SK6-0 (TRIPPE MFG. CO.), SUPER MAX (PANAMAX) or MP1 (ITW LINX).

¡When you operate this product, the power outlet should be near the product and easily accessible.

¡If the following message is displayed when the unit is plugged in, the recording paper set lever is released.

Display: CHECK LEVER

Move the lever back (see step 3 on page 20).

preparation Initial

21