
Operations
When a function does not work, check here before requesting help!
General
PROBLEM | CAUSE & REMEDY |
|
|
I cannot make and receive calls. | ¡The power cord or telephone line cord is not connected. Check the |
| connections (see page 21). |
|
|
I cannot make calls. | ¡The dialing mode setting is wrong. Check the setting and change |
| to TONE or PULSE (see page 42). |
|
|
The main unit does not work. | ¡Disconnect the unit from the telephone line and connect the line to |
| a known working telephone. If the working telephone operates |
| properly, call your service center to have the unit repaired. If the |
| working telephone does not operate properly, contact your |
| telephone company. |
|
|
The handset does not work. | ¡Check the settings (see pages 27 and 28). |
| ¡Charge the battery fully (see pages 27 and 28). |
| ¡Clean the charge contacts and charge again (see page 115). |
|
|
The main unit does not ring. | ¡The ringer volume is set to OFF. Adjust to a suitable level (see |
| page 29). |
|
|
The handset does not ring. | ¡The ringer volume is set to OFF. Press (LOUD/RINGER) when the |
| TALK/BATT LOW indicator light is off. |
|
|
The REDIAL/PAUSE button does | ¡If this button is pressed during dialing, a pause will be inserted. If |
not function properly. | pressed immediately after a dial tone is obtained, the last number |
| dialed will be redialed. |
|
|
The receive mode does not function | ¡A distinctive ringing pattern is set (see page 66). |
as explained on pages 56 and 57. |
|
|
|
During programming, I cannot enter | ¡Whole or part of the number is the same as another code or ID. |
the fax activation code or the | Change the number (see pages 62 and 68). |
remote TAM activation ID. |
|
|
|
An alarm tone sounds when you | ¡You are too far from the main unit. Move closer and try again. |
press (TALK) or (INTERCOM). | ¡Place the handset on the main unit and try again. |
| ¡The power cord is disconnected. Plug in the power cord. |
|
|
An alarm tone sounds continuously | ¡Move closer to the main unit quickly, or the call will be terminated |
while using the handset. | within 60 seconds. |
| ¡The power cord is disconnected. Plug in the power cord. |
|
|
Static, sound cuts in/out, fades. | ¡Locate the handset and the main unit away from electrical |
Interference from other electrical | appliances. |
units. | ¡Move closer to the main unit. |
| ¡Raise the main unit antenna. |
| ¡Press (CH) to change the channel. |
|
|
The unit stops working during | ¡Place the handset on the main unit and disconnect the power cord |
operation. | to reset the unit. Connect the power cord, then try again. |
|
|
98 | For Assistance, Call |
|
|