Compaq 4130T, 4150T, 4140T, 4131T Pointing Devices, 14. Removing the Pointing Device Touchpad

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

5.3.4Pointing Devices

There are two pointing devices available for the computer: a modular touchpad and a modular trackball. Both devices are removed and installed the same way.

To remove the pointing device, complete the following steps:

1.Disconnect the AC power (section 5.3.1).

2.Undock the computer from its auxiliary base, if necessary (See Section 5.3.2).

3.Remove the handle battery pack (Section 5.3.3).

4.Remove the DualBay device (Section 5.3.4).

5.To release the pointing device, push in the metal retaining clip 1 located in the wall between the DualBay and the pointing device bay.

6.While holding in the retaining clip, pull the pointing device straight out of the computer base 2 .

Figure 5-14. Removing the Pointing Device (Touchpad)

5-16 Removal and Replacement Procedures