Compaq 850 manual Software Support Information, Table G-2

Appendix G Compaq/ELSA GLoria II AGP Graphics Card

G.4 SOFTWARE SUPPORT INFORMATION

The ELSA GLoria II graphics card is fully compatible with software written for legacy video modes (VGA, EGA, CGA) and needs no driver support for those modes.

Drivers are provided with or available for the card to provide extended mode support for the current operating systems and programming environments such as:

♦Windows 2000

♦Windows NT 4.0

♦Autodesk AutoCAD R14 and 2000

♦Kintex 3D Studio Max

♦2D GDI

♦MS DirectDraw DX6-7, ActiveX, DirectX, Direct3D,

♦OpenGL 1.1 and 1.2

PCI bus configuration data:

Vendor ID: 10DEh

Device ID: 0150h

G.5 POWER MANAGEMENT AND CONSUMPTION

This controller provides monitor power control for monitors that conform to the VESA display power management signaling (DPMS) protocol. This protocol defines different power consumption conditions and uses the HSYNC and VSYNC signals to select a monitor’s power condition. Table G-2 lists the monitor power conditions.

Table G-2.Monitor Power Management Conditions

			Table G-2.
		Monitor Power Management Conditions
HSYNC	VSYNC	Power Mode	Description
Active	Active	On	Monitor is completely powered up. If activated, the inactivity
			counter counts down during system inactivity and if allowed to
			tiemout, generates an SMI to initiate the Suspend mode.
Active	Inactive	Suspend	Monitor’s high voltage section is turned off and CRT heater
			(filament) voltage is reduced from 6.6 to 4.4 VDC. The Off mode
			inactivity timer counts down from the preset value and if allowed
			to timeout, another SMI is generated and serviced, resulting in
			the monitor being placed into the Off mode. Wake up from
			Suspend mode is typically a few seconds.
Inactive	Inactive	Off	Monitor’s high voltage section and heater circuitry is turned off.
			Wake up from Off mode is a little longer than from Suspend.

G-4Compaq Personal Computers

Original - November 2000