Conair CHS-810 manual Installing the Knives, First install the rear, fixed knife, Service

8Undo and remove the socket cap screws (E) on the rear knife support rule (F).

✐NOTE: Hold the fixed knife and support rule before removing the last screw.

9Lift out the fixed knife together with the support rule.

10Clean the knife location.

11Put the support rule back loosely.

Installing the Knives

The knife attachments for both the fixed and rotating knives must be carefully cleaned.

First install the rear, fixed knife

1Install the rear fixed knife on the knife attachment.

2Screw in the socket cap screws (E), so that the support rule (F) lightly supports the knife.

3Press the knife firmly into the knife attachment to bed it down.

✐NOTE: The screws in the rear of the knife attachment are bonded in place.

✐NOTE: The knife has a fixed position and no adjustment may be done.

4Tighten screws (E), with alternating tightening torque to 29.5lb-ft (40 Nm).

Install the rotating knives. E F

✐NOTE: When the rotating knives are installed in a granulator with open cutter, the knives must always be pre-set before installation!

Pre-setting of knives for a granulator with open cutter is best done in a special pre- setting jig. The jig is not included when the machine is delivered, but is a very practical accessory which can be ordered. The jig and knife pre-setting is described in Section 11.

7 Service

S e r v i c e l 7 - 3