6Install screws (A) with washers (B), and tighten so that they hold

5Install one rotating knife at a time on the knife attachment on the rotor.

6Install screws (A) with washers (B), and tighten so that they hold

the knife lightly.

7Press the knife firmly into the knife attachment.

NOTE: The screws in the rear of the

knife attachment are bonded in place.

A, B

 

NOTE: The knife has a fixed position and no adjustment may be done.

8Tighten screws (A), with alternating tightening torque to 55.3 lb-ft (75 Nm).

NOTE: Granulators with open cutter – tighten the screws (A) with alternating increased torque to 162.3 lb-ft (220 Nm).

9Check that the rotating knife can pass the rear fixed knife freely.

If the knife can not pass freely – undo screws (A) and press the rotating knife firmly into the knife attachment.

Undo screws (E) and press the fixed knife firmly into the knife attachment.

10Check the knife clearance with a feeler gauge. The clearance should be 0.008 - 0.012 in. (0.20 - 0.30 mm), check at the outer edges of the knives.

11Install all the rotating knives.

12Press the knife firmly into the knife attachment.

13Tighten the screws (A) with alternating increased torque to

55.3lb-ft (75 Nm).

NOTE: Granulators with open cutter – tighten the screws (A) with alter-nating increased torque to 162.3 lb-ft (220 Nm).

14Check that each rotating knife can pass the rear fixed knife freely.

If any rotating knife can not pass freely – undo the screws (A) and press the knife firmly into the knife attachment.

15Check the clearance of each rotating knife with a feeler gauge The clearance should be 0.008 - 0.012 in. (0.20 - 0.30 mm), check at the outer edges of the knives.

7 - 4 l Service

Page 40
Image 40
Conair CHS-810 manual Install screws A with washers B, and tighten so that they hold