Cooper Lighting S280-79-10 manual 39

!

SAFETY FOR LIFE

S280-79-10

To insert wire:	TB1
	(Top View)

1.Insert 3/32 inch flat-

blade screwdriver into
Wire Release and							TB1
Locking hole.										AØ
2. Carefully insert the			240Vac CLOSING			16
			OPTION
screwdriver along side							15
the locking clamp.				Y' VOLTAGE		14
3. Pull toward the center			CLOSING	120Vac
			VOLTAGE	B' VOLTAGE		13
of terminal block TB1
				120Vac
until the locking clamp				NEUTRAL		12			BØ
opens.				SOURCE 2
4. Insert wire into Terminal				NEUTRAL		11
				SOURCE 1
Connection hole.				NEUTRAL		10
5. Release screwdriver.		Note: Only slight pressure is
			AC
6. Carefully pull wire to be		required to open the			ZØ	9
sure it is secure.		locking clamp. Excessive	CUSTOMER	SOURCE 2	YØ					CØ
		pressure can damage	CONNECTIONS	POWER		8
Wire Release		the terminal block.			XØ	7
and Locking Hole
								HOT (LV Closing Output)
			POWER	OUTPUT		6
				VOLTAGE
Terminal			SOURCE
	TB1			NEUTRAL		5		NEU (LV Closing Output)
Connection Hole			OUTPUT
	16							NEU
				*NEUTRAL		4
	15		AC
								CØ
	14				CØ	3
	13		CUSTOMER					BØ
				SOURCE 1	*BØ
Connection	12	3/32 inch	CONNECTIONS				2
				POWER				AØ
Wire	11	Flat-Blade			AØ	1

10Screwdriver

9

8	*REQUIRED FOR
	CONTROL OPERATION

Figure 34.

Form 5 and Form 5 UDP Power and Low Voltage Closing customer connections to terminal block TB1 (120Vac or 240Vac Wye Connection).

			TB1		AØ
240V CLOSING			16
OPTION
			15
			14		BØ
			13
			12
			11
		ZØ	10		CØ
AC
		YØ	9
CUSTOMER	SOURCE 2	XØ
			8
CONNECTIONS
	POWER
			7
POWER	OUTPUT			HOT (LV Closing Output)
			6
	VOLTAGE
SOURCE
	OUTPUT		5	HOT (LV Closing Output)
OUTPUT	VOLTAGE
		*CØ	4	CØ
AC
				BØ
		BØ	3
CUSTOMER				AØ
CONNECTIONS	SOURCE 1	*AØ	2
	POWER
			1

*REQUIRED FOR

CONTROL OPERATION

SEE POWER SUPPLY

MODULE FOR

CORRECT VOLTAGE

Figure 35.

Form 5 and Form 5 UDP Power and Low Voltage Closing customer connections to terminal block TB1 (120Vac or 240Vac Delta Connection).

39