1.3.10.Verify Proper Installation
The following procedure should be used at each telephone to check for proper installation. Also use this procedure any time you are experiencing difficulty. The phone must be connected to the AC power supply, line 1 must be connected to the line 1 jack, and the phone must have been assigned an intercom station number. First, verify that line 1 is connected to the same telephone number at all the telephones. To do this, press the line 1 button at one of the telephones. The line 1 LED should be green, the speakerphone LED should be red, and dial tone should be heard from the speaker. Now go to each of the other stations and make sure that each line 1 LED is red. Next, make sure that lines 2, 3 and 4 are connected the same at all the phones by performing the following steps at each telephone:
a.Press the line 1 button. The line 1 LED should be green, the speakerphone LED should be red, and dial tone should be heard from the speaker.
b.Dial the telephone number for line 2. The line 2 LED should flash slowly. If the line 2 LED does not flash, then line 2 is improperly connected to this telephone.
c.If this telephone utilizes line 3 and/or line 4, repeat steps 1 and 2, substituting the respective phone number(s) in step 2.
2.SYSTEM PROGRAMMING
2.1.Station Number Assignment
Each station must be assigned a different station number.
To assign a number to a station:
a.Press MENU. The display will read “Phone Setting”
b.Press the soft key under ENTER. The display will show the currently assigned station number.
c.Press the soft key under CHANGE repeatedly, until the desired station number is displayed. The choices are Station #01 through Station #16.
d.Press MENU to exit.
Until a telephone is assigned a station number, the telephone will not operate correctly. (see above)
Note: One phone in the system must be set as Station #01 in order to program all the system features. Certain features can only be programmed at station 01 and will only function at station 01.
2.2.Station Name Assignment
You may give a name to each of your
To assign a name to a station:
a.Press MENU. The display will read “Phone Setting”
b.Press the soft key under ENTER.
c.Press the Down Arrow repeatedly until the display reads “Station Naming”
d.Press the soft key under ENTER. The display will show the currently stored name for station #01, or indicate “No Name” if no name has yet been given to station #01.
e.Press soft Key under CHANGE if you wish to store a new name for station #01, or press DOWN ARROW repeatedly until you see the station number that you want to name, and then press the soft key under CHANGE.
9 | 2750 User Guide Version 1.3 |
