LEVELING THE FRONT TABLE
See Figure 24.
If there are any high or low areas on the front table, they should be removed by adjusting the leveling screws in the center holes on the front table.
•Place the rear table on its edge across the front table to check for gaps.
•Adjust gaps of less than 1/32 in. in the center of
the table by turning the setscrew with a flat blade screwdriver until the setscrew touches the frame.
Then lightly secure the center pan head screw with a phillipsscrewdriver.
•For a gap of more than 1/32 in. in the center of the table, raise the center by turning the setscrew against the frame. Then lightlysecure the center pen head screw with a phillipsscrewdriver.
BFor a gap of more than 1/32 in. on the sides, lower the center of the table by tighteningthe center pan head screw with a phillipsscrewdriver. Then tighten the setscrew.
PHILLIPSSCREWDRIVER
ONPANHEADSCREW
SETSCREW
REARTABLEFRONTTABLE
Fig. 24
INSTALLING REAR TABLE, SPACER TABLE, FENCE, AND CLAMPS
See Figures 25A - 25C_
The placement of the tables and fence may need to be changed for different cuts, depending on the size of the workpiece and the positionof the blade. The fence should be installed next to the front table for
maximum depth capacity; it should be installed in the middle for maximum cross cut capacity; and installed all the way back for maximum rip capacity.
BLocate the fence, the spacer table, the rear table, and two unassembledclamps, which consistof the following hardware:
2 cup washers
2 clamp brackets
2 square nuts
2 thumbscrews
•Place the fence behind the front table, then the spacer table behind it, and then the rear table behind it,
•Slip a square nut intothe slot of each clamp bracket.
BPlace a thumbscrew intothe end of the clamp bracket farthest from the slot. Thread it intothe
square nut.
Note: If the screw is inserted in the wrong end of the bracket, the clamp will not work.
•Place the clamp bracket into the rectangle holes in the table support. Hold the cup washer againstthe rear table and turn the thumbscrewclockwiseuntil it snaps into the cup washer.
•Tighten the thumbscrews to clamp the table sec- tions intoplace.
REARTABLEFENCE
SPACERTABLEFRONTTABLE
Fig. 25A
33rRIIR'SMmN"RADIALSAW$1S,220,_1
