INSTALLING RIP SCALE INDICATORS
See Figure 28,
SCREWS
The rip scale indicators on the arm show the distance between the blade and the rip fence with the fence in the front and rear positions.The upper scale is used when the fence is positioneddirectly behind the front table. The lower scale is used when the fence is at the extreme rear, directly in front of the column,
The
RIP SCALE
INDICATOR
CARRIAGE
SPEEDNUT
•Remove the followingfrom a small hardware bag.
2 rip scale indicators
4 screws
2 speed nuts
•On the left of theradial arm saw, remove the carriage lock knob and spring.
•Remove the two carriage cover screws and the carriage cover.
•Insert a speed nut inside the carriage cover with the flat side up. Place the scale indicatoron top of the carriage cover and attach with two screws. Se- curely tighten screws.
•Replace the carriage cover and tighten the carriage cover screws.
•Replace carriage lock knob and spring.
•Repeat for the right side.
SPRING |
|
CARRIAGE | SCREWS |
| |
LOCKKNOB | Fig. 28 |
To complete setting up your saw, continue with the
Adjustment procedures.The adjustments should be checked regularly, depending on usage. Your saw will provide accurate cuts with fine tolerances as long as you protectthe accuracy with frequent alignment checks. The radial arm saw can perform a wide range of high quality cuts.
The final step will be connecting the control cut device. The control cut device offers many benefits. As it increases operator control, it eliminates the risk in a cross cut of the saw "climbing" out and over the workpiece at the operator. Feed control of the blade as it cuts through the workplace increases, as does the accuracy of the cut. The following adjustments
need to be completed before the control cut device is connected.
Your radial arm saw is designed to perform a variety of | _, CAUTION: Failure to check alignments and |
complex cuts with fine tolerances. A weekly alignment | perform the adjustments in the initialset up or on |
check ensuresthat your saw can performwith precision. | a frequent basis can result in poor performanceor |
It takes about ten minutes and the results is batter | machine damage. |
performance and a longer life for your saw. |
|
Perform the checks in the order given. If you miss an |
|
adjustment, go back to the missed adjustment and |
|
repeat all steps from that point forward. |
|
r'RARYMAN'RADIALSAWS15,32038136
