Cub Cadet SC2400 Replacing the Tail Light Bulb, Replacing the Turn Signal / Hazard Lights Bulb

15. SERVICING THE ELECTRICAL SYSTEM

■Replacing the Tail Light Bulb

1.Park the tractor safely.

2.Stop the engine and remove the starter key switch.

3.Remove the two screws and lens from the assembly.

4.Push down and rotate the bulb to remove it.

5.Push the new bulb into the socket and rotate to lock it into position.

6.Check that the tail light lights normally.

7.Reinstall the lens.

(A)Screw

(B)Lens

(C)Bulb

■Replacing the Turn Signal / Hazard Lights Bulb

NOTE:

●The turn signal / hazard lights can be serviced after removing the front or rear lens assembly.

1.Park the tractor safely.

2.Stop the engine and remove the starter key switch.

3.Remove the lens from the light assembly.

4.Push down and rotate the bulb to remove it.

5.Push the new bulb into the socket and rotate to lock it into position.

6.Check that the turn signal / hazard lights operate normally.

7.Install the lens.

(A)Lens

(B)Bulb

(A)

P3014936

(B)(C)

P3014953

(A)

P3014937

(B)

P3014954

15-9 Sc2400 Operator’s Manual