Cub Cadet SC2400 manual Hydraulic System, 1. 3-PointHitch Control System, Sc2400 Operator’s Manual

11.HYDRAULIC SYSTEM

11.HYDRAULIC SYSTEM

WARNING

ALWAYS fully release the internal hydraulic pressure before disconnecting a hydraulic line. ALWAYS ensure that all connections are tight and all the

hydraulic lines, pipes and hoses are free from wear or damage.

1. 3-Point Hitch Control System

IMPORTANT:

●NEVER operate the 3-point hitch control / cutting height adjustment lever before the engine has been sufficiently warmed up.

●If the 3-point hitch control / cutting height adjustment lever is operated before the engine has been warmed up, the hydraulic system can be damaged or develop a failure.

●If abnormal hydraulic noise occurs after the 3-point hitch has been raised, then misadjustment or failure of the hydraulic system should be suspected.

In such a case, immediately stop operation and request your local Cub Cadet Yanmar dealer to service or repair the tractor.

■Operating the 3-Point Hitch Control / Cutting Height Adjustment Lever to Raise or Lower the 3-Point Hitch

Use the 3-point hitch control / cutting height adjustment lever, when raising or lowering the Mid- or Rear-mounted implement.

1.Shift the 3-point hitch control / cutting height adjustment lever to the intended position.

2.Adjust the position stop knob to set the lowest position of the implement to the desired height.

(A)3-point hitch control / cutting height adjustment lever

(B)Position stop knob

(a)Moving the 3-point hitch control / cutting height adjustment lever forward will lower the implement.

(b)Moving the 3-point hitch control / cutting height adjustment lever backward will raise the implement to raise higher.

	(A)
(a)	(b)
(B)
3014918c

11-1 Sc2400 Operator’s Manual